Description
The Burn Proof Gear Suppressor Cover Heavy is a two-material thermal barrier built for sustained fire. The outer layer is DuPont Kevlar rated to 1,000 degrees F, which BPG equates to roughly 180 rounds of M855 on full auto. The inner liner is fiberglass mesh sleeving rated to 2,000 degrees F, providing a secondary thermal barrier between the can surface and the Kevlar shell.
The cover is intentionally manufactured 0.5 inches longer than the stated suppressor length. That extra material cinches around the front and rear of the can, holding the cover in place without additional fasteners or hardware. Available in Black and Flat Dark Earth.
- Outer material: DuPont Kevlar, 1,000°F maximum operating temperature
- Inner liner: fiberglass mesh sleeving, 2,000°F maximum operating temperature
- Dimensions: 6" length x 1.5" diameter
- Cover is 0.5" longer than suppressor length to allow cinching at both ends for a no-slip fit
- Full auto capable up to 1,000°F
- Available in Black (BPG-SC-H-6-1-5-BLK) and Flat Dark Earth (BPG-SC-H-6-1-5-FDE)
Will this fit my suppressor?
The 1.5" diameter is the fit-critical dimension. Verify your suppressor's outer diameter before ordering. The 6" length assumes a suppressor of approximately 5.5"; the extra 0.5" is what allows the cinching fit at each end.
What is the difference between the Heavy cover and a standard suppressor cover?
The Heavy variant uses the dual-layer Kevlar and fiberglass mesh construction for higher sustained-fire thermal loads. Verify which BPG tier matches your expected round count and fire rate before selecting.
